#Australian standard as2870 pdf download software

SECTION 2 SITE CLASSIFICATION2.1 GENERAL. The number and date of the Standard should therefore be clearlyidentified.

#Australian standard as2870 pdf download software

Standards Australia will also permit the inclusion of its copyright material in computer software programs forno royalty payment provided such programs are used exclusively in-house by the creators of the programs.Д¬are should be taken to ensure that material used is from the current edition of the Standard and that it is updatedwhenever the Standard is amended or revised. Standards Australia will permit up to 10 percent of the technical content pages of a Standard to be copied foruse exclusively in-house by purchasers of the Standard without payment of a royalty or advice to StandardsAustralia. Requests for permission and information on commercial software royalties should be directed tothe head office of Standards Australia. Permission may be conditional on an appropriateroyalty payment. Exceptwhere the Copyright Act allows and except where provided for below no publications or software produced byStandards Australia may be reproduced, stored in a retrieval system in any form or transmitted by any meanswithout prior permission in writing from Standards Australia. A normative appendix is an integralpart of a Standard, whereas an informative appendix is only for information andguidance.Д¬opyright STANDARDS AUSTRALIAUsers of Standards are reminded that copyright subsists in all Standards Australia publications and software. The terms normative and informative have been used in this Standard to define theapplication of the appendix to which they apply.

All other details are purely illustrative. The Figures are intended to show only the structural proportions of the footingsystem. The Notes to the Figures in Section 3 form part of the mandatory provisions of thisStandard. (d) Tolerance of the superstructure to movement. (c) Distribution to the foundation of the applied loads. (b) Settlement of compressible soils or fill. (a) Swelling and shrinkage movements of reactive clay soils due to moisture changes. The Standard takes account of the following: Although awide range of conditions is covered, this Standard places particular emphasis on thedesign for reactive clay sites susceptible to significant ground movement due to moisturechanges. The purpose of this Standard is to establish performance requirements and specificdesigns for footing systems for foundation conditions commonly found in Australia and toprovide guidance on the design of footing systems by engineering principles.

This Standard was prepared by the Standards Australia Committee BD/25 on ResidentialSlabs and Footings to supersede AS 2870.11988 and AS 2870.21990. PUBLISHED BY STANDARDS AUSTRALIA(STANDARDS ASSOCIATION OF AUSTRALIA)1 THE CRESCENT, HOMEBUSH, NSW 2140 Residential slabs and footingsConstruction